Hydraulic Continuous Control CAN CNH

Compatible with:

CASE:

Maxxum 115 ActiveDrive 8,  Maxxum 125  ActiveDrive 8, Maxxum 135 ActiveDrive 8, Maxxum 14 5 ActiveDrive 8

New Holland:

T6.145 Dynamic Command, T6.155 Dynamic Command, T6.165 Dynamic Command, T6.175 Dynamic Command

Steyr:

4115 Profi S-Control 8, 4125 Profi S-Control 8, 4135 Profi S-Control 8, 4145 Profi S-Control 8, 6 14 5 Profi S-Control 8

Mounting kit with M30 rotary switch . Electronic hydraulic valves are required.

The Hydraulic Continues Control CAN continuous oil allows you to deliver continuous oil to the controller from the outside. Electronic John Deere rear axle or intermediate shaft control units are required for this electronic assembly.

Practical examples:  You want to switch on an oil-driven pump from the outside. You want to fill a manure trailer with a hydraulically operated pump from the fender, without having to climb back on the tractor.

What we do: We have developed an electronic device which allows you to operate the continuous oil function from the outside, using two buttons. You press a button and your controller continuously delivers hydraulic oil. Pushing the button briefly deactivates this function. The machine operator can re-teach the oil quantity to the controller at any time! In addition, the set oil quantity is always output to the controller, no matter how high the quantity set on the GS3 monitor in the cabin. The installation time is also drastically reduced, since the electronics are installed outside of the cabin, directly on the controllers, with original plugs.  Installing the electronic assembly takes approx. 0.5 – 1 hour.

Your advantages at a glance:

| No need to spend time climbing up and down to attach equipment

| Lifting and lowering speeds can be adjusted independently

| Setting via a learning function

| Extremely short installation time

| Excellent reliability

| Install with original plug connectors

| First-class support direct from the manufacturer