Feeding & stable technology

Is your control unit for feeding or barn technology defective?

If a control unit, PCB, or electronic box in feeding or barn technology fails, it can quickly lead to problems in daily operations. Milking systems, cleaning automats, feeding systems, and other electronic components in barns rely on control systems that function reliably.

We inspect and repair control units, PCBs, and electronic boxes used in feeding and barn technology, including manufacturers such as DeLaval and Alfa Laval. In many cases, repair is a cost-effective alternative to purchasing new equipment or sourcing difficult-to-find spare parts.

Repair instead of replacement parts or new purchase

Especially for older systems, suitable spare parts for Alfa Laval or DeLaval components are not always available at short notice. Replacing complete assemblies in cleaning automats, milking machines, or feeding control systems can also be expensive.

A professional repair of the existing PCB or control unit offers many advantages:

• lower costs compared to purchasing new equipment
• preservation of the existing system
• reduced downtime through targeted fault diagnosis
• sustainable use of existing electronics
• repair possible even when spare parts are difficult to obtain

Which feeding and barn technology components do we repair?

• Control units and electronic boxes
• PCBs from milking machines and milking systems
• Feeding computers and control systems for feeding equipment
• Assemblies from cleaning, dosing, and barn technology systems

Whether it is a single PCB, a complete control unit, or an electronic box: our technicians carefully inspect the assembly and carry out the repair professionally.

Typical faults in control units, PCBs, and electronic boxes

Electronics used in barn technology are often exposed to demanding conditions. Moisture, temperature fluctuations, dirt, voltage spikes, or mechanical stress can lead to failures.

Typical faults include:

• Control unit no longer starts
• PCB shows visible damage
• Error messages on the device or system
• Milking machine or milking system does not respond correctly
• Feeding computer fails
• Communication errors between control system and equipment
• Damage caused by moisture or corrosion

After the initial inspection, we analyze the fault, repair defective components, and test the functionality of the electronics before returning them.

How the repair process works at Ilgenfritz

The repair process is simple and transparent:

1. Create a repair order
   Register the defective control unit, PCB, or electronic box via our service portal.
2. Send in the device
   The defective assembly is securely packaged and sent to Ilgenfritz Mechatronics.
3. Perform fault diagnosis
   Our technicians inspect the electronics and identify the defect.
4. Repair and function test
   Defective components are repaired or replaced and then tested.
5. Return shipment
   After successful repair, you will receive your tested electronics back.

Have your defective feeding and barn technology electronics inspected and professionally repaired.

Create a repair order now and send in your defective control unit.